CAUSE: Manual Bypass Tray is not properly adjusted.

SOLUTION: Perform the Manual Bypass Tray Adjustment using the below procedure:

1.Enter Service Mode.
2.Select [Machine] on the touchscreen.
3.Select [Manual Bypass Tray Adjustment] on the touchscreen.
4.Select [Max. Width] on the touchscreen.
5.Load the bypass tray with paper having a width of 297mm.
6.Press the Start key on the control panel and verify that the result is [OK] on the display.
7.Select [Min. Width].
8.Load the bypass tray with paper having a width of 100mm.
9.Press the start Key and verify that the result is [OK] on the display.